APM 2.8 Multicopter Flight Controller 2.5 :
- Arduino Compatible!
- Can be ordered with top entry pins for attaching connectors vertically, or as side entry pins to slide your connectors in to either end horizontally
- Includes 3-axis gyro, accelerometer and magnetometer, along with a high-performance barometer
- Onboard 4 MegaByte Dataflash chip for automatic datalogging
- Optional off-board GPS, uBlox LEA-6H module with Compass.
- One of the first open source autopilot systems to use Invensense's 6 DoF Accelerometer/Gyro MPU-6000.
- Barometric pressure sensor upgraded to MS5611-01BA03, from Measurement Specialties.
- Atmel's ATMEGA2560 and ATMEGA32U-2 chips for processing and usb functions respectively.1. data transmission port
2. analog sensor port
3. autostability gimbal output
4. ATMEGA2560 SPI online programming port (be useful for optical flow sensor)
5. USB port
6. remote control input
7. function selection jumper
8. GPS port
9. 12C external compass port
10. ATMEGA32U2 SPI online programming port
11. multifunction configurable MUX port (OSD is the defaulted output)
12. current voltage port
13. ESC power supply selection jumper
14. ESC output port
1* HMF Y600 Tricopter 3 Axis Copter Frame Kit
3*750KV Brushless Disk Motor
3*HOBBYWING Platinum-30A-Pro 2-6S 30A Speed Controller ESC
2*Three-hole High Quality Carbon Fiber 15x5.5 Propeller set
1*APM 2.8 Multicopter Flight Controller 2.5
1*6M GPS with Compass L5883 25cm Cable
1* 10cm Servo Extension Lead Wire Cable
1*GPS Folding Antenna Mount Holder
1*RadioLink AT10 2.4GHz 10CH Remote Control System TX&RX
1*RC B3 Pro Compact Balance Charger
1*11.1V 3300Mah 25C lithium battery
1* Aluminum 2-axis Gimbal Camera Mount PTZ
No customer comments for the moment.
There are no products matching to show.